×Read this message from Erik, founder of YouMagine

Report inappropriate content

Venus De Milo with built in Supports

I wanted to print this without bed supports. Used Meshmixer to add supports in the most acute areas. Printed great. Simply snip off supports at point.

Printed at 0.3, no infill, printed about 9 inches tall.

I "reduced" original 3d scan from CosmoWenman in MM.

Print Settings

Printer: Monoprice i3 Plus
Rafts: No
Supports: No
Resolution: 0.3

Notes:
Used a brim only.

Your email is used to contact you if we need more information.


Back to design