Report inappropriate content

ultimaker syringe extruder II

The concept is more or less the other way round. The filament pulls the syringe and squeeze the material out.
for more images and movies, see http://www.facebook.com/europerminutedesign

Resize the shapes suited for your syringe.
Print the syringe holder.
Print the end stop enlargers.
Screw same [ultimaker spare] m3 bolts through the holes to fixate the syringe holders to the moving head.
Attache everything.
Generate gcode
Without temperature settings
Very low extrusion speed
Open the gcode in a text editor and replace "E" with "E-"
[we want to pull the filament not push it, you can also change the firmware, but this was easier for me]
Print and use the live control panel in repg to tune the flow and speed.

Your email is used to contact you if we need more information.


Back to design