×Read this message from Erik, founder of YouMagine

Report inappropriate content

UM2 - Plexi Hook

print 2 pieces (one mirrored if you want to)


Assembly:

- place the hooks on top of the plexiglass

- mark the holes

- remove the hooks and drill the holes (do it slowly or it may crack)

- cut the tip of the filament flat, chamfer a little bit (1mm)

- push the filament in the hole as much as you can, cut the filament (small cut then break it)

- with the drill and drill bit push the filament a little further in.

- clean

- enjoy

Your email is used to contact you if we need more information.


Back to design