×Read this message from Erik, founder of YouMagine

Report inappropriate content

UM2 Dual Fan Shroud

Labern's Dual Fan Shroud For Original and Olsson Heaters Block Setups

NEW, Have an I2k Shroud, It will set the shroud at the correct height when using the PTFE I2K insulator and the spring replacement found here: https://www.youmagine.com/designs/um2-spring-replacement-for-i2k

Dual Nozzle Shroud Found Here: https://www.youmagine.com/designs/um2-dual-nozzle-fan-shroud

Disscussion about the fan shroud is found here: http://umforum.ultimaker.com/index.php?/topic/10554-um2-fan-shroud-replacement/?p=102188

Please place comments in the discussion

Will require good insulation from the heater block and not recommended for high temp prints as it could deform. Working on a metal design.

Spacers are required to stop the hot end securing screws from hitting the shroud.

Make sure your temps arn't to high so overhangs are clean and the fit is correct. Can be printed with no infill.

Added an enclosed design for people with Heat Temp Error Issues. Thanks Duriel for your input on this.

V3 increased nozzle hole side

Your email is used to contact you if we need more information.

Back to design