×Read this message from Erik, founder of YouMagine

Report inappropriate content

UM2 Dual Nozzle Fan Shroud

Single Nozzle Version found here: https://www.youmagine.com/designs/um2-dual-fan-shroud

Disscussion about the fan shroud is found here:http://umforum.ultimaker.com/index.php?/topic/10554-um2-fan-shroud-replacement/?p=102188

Please place comments in the discussion

Will require good insulation from the heater block and not recommended for high temp prints as it could deform. Working on a metal design.

Spacers are required to stop the hot end securing screws from hitting the shroud.

Make sure your temps arnt to high so overhangs are clean and the fit is correct. Can be printed with no infill.

Your email is used to contact you if we need more information.

Back to design