×Read this message from Erik, founder of YouMagine

Report inappropriate content

Ultimaker² Corner

I wanted to make a small addition to the printer. A nice thing besides being practical. 
I noticed that the vibrations are transmitted very well at the table. I test the gasket and the vibrations is absorbed perfectly. I create a design to hold the gasket and affixed the text " Ultimaker ² Corner ". 
I now offer this little gadget to improve your UM ² in addition to reduce the noise. You will need a little gasket in length, width, height is 50x50x5 mm.

Your email is used to contact you if we need more information.


Back to design