Report inappropriate content

Make: Raspberry Pi Zero Case

The Raspberry Pi Zero is a new milestone in low cost computing. We here at Make: wanted to ensure that you have a safe way to house and transport your new pocket power house so we designed this easy to build case. No screws or extra parts required!

This case was designed using OnShape and is a public model that can be edited at: http://bit.ly/1XOjrXN

Designed by Make's Digital Fabrication Editor, Matt Stultz.

Read more at https://makezine.com/2015/12/08/3d-print-the-make-raspberry-pi-zero-case/

Settings

This was designed to be printed at .2mm but should be good at finer resolutions. No rafts or support needed.

Post Print

If you wish to access the GPIO pins, the thin panels in the base or lid can be cut away using a razor.

Your email is used to contact you if we need more information.


Back to design