Span2 me 300by300

Richard M

  • Joined on Feb 08, 2014
  • Unknown
  • 50 times favorited
  • 23,069 times downloaded

Activity

Updated My mishmash Prusa i3 over 1 year ago
Updated Large M8 handle over 1 year ago
Published Large M8 handle over 1 year ago
Updated Beefier mini t-driver over 2 years ago
Published Beefier mini t-driver over 2 years ago
Favored Cube Puzzle Quartet about 3 years ago
Commented on TinyG v8 Case almost 4 years ago
What are the connectors? Been looking for something similar myself.
Commented on E3d V6 hot end mount almost 4 years ago
When I fitted an e3d to an ultimaker I bought and fitted a cheap DC-DC converter for the fans. eg £0.99 http://www.ebay.co.uk/itm/171814039953?_trksid=p2057872.m2749.l2649&ssPageName=STRK%3AMEBIDX%3AIT
Favored Original Draudi about 4 years ago
Commented on E3d V6 hot end mount about 4 years ago
<p>Just tried as I liked the look however due to a few issues with it I can't really use it. These aren't complaints they're just comments as I really appreciate the work that went into it.</p><p>1) The 12mm X hole seems too large for the bearing, it fits but it's just a lot looser than the Y hole - just me?</p><p>2) The lack of nut traps means I've tapped the holes but that makes me wary of taking it apart and putting back together again.</p><p>3) The left/right fan clearance doesn't allow me to use the Ultimaker original heater block.</p><p>4) You have to buy new fans for the hot end as it doesn't use the Ultimaker originals - and they have to be very thin otherwise they interfere with the xy blocks.</p><p>Still it's a thing of beauty and printed really well even without any support.</p>
Favored E3d V6 hot end mount about 4 years ago
Followed Michael over 4 years ago
Contributed on Ratcheting Cable Clamp over 4 years ago
Carousel thumb 2015 02 27 11.38.39
Printed on:
Prusa i3
Result:
Perfect. Just drilled out the hole slightly to fit an M5 bolt.
Commented on Ratcheting Cable Clamp over 4 years ago
Any chance of the source files used to generate the STLS? I'd like to adapt it for a metric M5x12 button head screw with a nut trap in one of the areas.
Favored Ratcheting Cable Clamp over 4 years ago