Span2 xperiaz2 1290

Sander

About

Working @ Ultimaker

Less details
More details

Activity

Favored Beard-i-Bot about 3 years ago
Favored UltiSandervG about 3 years ago
Updated Ultimaker printhead spacer over 3 years ago
Published Ultimaker printhead spacer over 3 years ago
Published Cycle print v2 almost 4 years ago
Followed jazmy over 4 years ago
Published OK hand over 4 years ago
Favored Geek Pride Day Glasses about 5 years ago
Commented on Sunken Coffee Mug over 5 years ago
Depending on which material you print it with, actually drinking coffee (hot drinks) from this (or any print) is not recommended.
Favored Recreus Sandals over 5 years ago
Commented on World Cup Mascots almost 6 years ago
@ Vdesmedt + Didierkl: Speciaal voor jullie een belgische duivel toegevoegd! Nou moeten jullie wel beloven te winnen op het WK :)
Commented on World Cup Mascots almost 6 years ago
I notified my colleague from support to get back with you :)
Commented on World Cup Mascots almost 6 years ago
Hi Jroen, did you read this tip: All of the Mascots should print without support. Remember to activate Combine Everything Type B (Under Cura - Expert Settings - Fix Horrible) to get the best results. ? I have printed several lions, big and small, and they all came out fine :)