Activity
Favored Epoxy Mixer Tray and Applicator (stackable) over 3 years ago
Contributed on CNC Dust Shoe and Cyclone over 3 years ago

- Printed on:
- Infitary M508
- Result:
- Printed great without supports and the mating flange on the print bed. Did not build the cyclone, because I already had one.
- Feedback:
- Thanks for this great design! I have seen many dust shoes, but this is by far the best. Only improvement I can think of would be making the lower part a bit wider in the spindle area so that one can mount the whole thing a little higher, in case extra length for large / deep 3d parts is needed, where the collet needs to dive lower than the material surface.
Favored Quick Fill 'n Pour 3 over 3 years ago
Favored Swirling Water Unit - Vortex water nozzle - Vortex Process Technology (VPT) over 3 years ago
Favored UM2 - Bed leveling guide over 3 years ago
Favored Electrical Compressor over 3 years ago
Favored Warning Signs over 3 years ago
Favored Filament joiner for multicoloured printed 3D objects over 3 years ago
Followed Thomas Sanladerer over 3 years ago
Favored small box with printed-in-place lid over 3 years ago
Favored Universal Pellet Extruder - RepRap 3D Printing over 3 years ago
Favored Dust Filter over 3 years ago
Favored Filament Clip 3mm or 1.75mm over 3 years ago
Favored Universal spool holder over 3 years ago
Favored T-Slot Runners for Bosch GTS 10 XC Table Saw over 3 years ago
Favored Induction Sensor Clamp (Cylinder Type) for Printrbot Smalls Kit over 3 years ago
Favored The Great Buddha at Kamakura, Japan over 3 years ago
Favored Cap and sprout for silicone sealant bottle over 3 years ago