9407b6cfd1da2f009801d52cc4d8029f?default=blank&size=170

siffonem

  • Joined on Dec 06, 2017
  • Unknown

Activity

Commented on Skylake delid tool about 4 years ago
Should work
Commented on Skylake delid tool about 4 years ago
It will go with only side so little sanding should do the trick, now its just too tight so wont dare to press it hard
Commented on Skylake delid tool about 4 years ago
Actually it should work, its just a tight fit and i dont want to ruin my cpu. 8700K has two set of "ears" that one set is meant to go to those two cuts in this tool. I was trying to get the ones that are higher on ihs but then ihs is too wide to go flush, flipped ot 90 degrees and it can go flush but its a very tight fit
Commented on Skylake delid tool about 4 years ago
Anyone successfully used with coffee lake cpu? Test fitted my i7-8700K and it didnt go flush (too wide ihs). But those two cutoffs didnt grab ihs, feels like it might hold still enough but didnt test it.