stylewarz

Joined on Oct 22, 2015
Unknown
3 times favorited
362 times downloaded

Printers

Ultimaker 2 Extended
Ultimaker 2 Extended
Stylewarz 3D Printer
Definitely my favorite at the moment.
Rostock Max
Rostock Max
Stylewarz 3D Printer
Hard to Calibrate and bigger prints don't turn out nice. Not so much a fan. Should have bought the Ultimaker in the first place.

Contact

Activity

Commented on Fan Mount (UM2 + Olsson block) over 7 years ago

No worries at all. Let me see how I could figure out where there are a few tweaks to make and I'll post them here. Nether the less, great design! Looks stealthy

Commented on Fan Mount (UM2 + Olsson block) over 7 years ago

I'm not sure what I've done wrong. But when I want to mount it to my Ultimaker2Extended the Fan Mount touches the front right screw of the hotend carage. When looking underneath the Hotend does not stick out enough. Is this an Extended "problem"?

Contributed on Fan Mount (UM2 + Olsson block) over 7 years ago

Printed on:: Ultimaker - The Ultimaker 2

Commented on Low friction UM2 spoolholder over 7 years ago

I love this holder. Would it be possible to get the Core 2 in a 100mm version. Some of my 1KG spools are a lot deeper and therefore don't fit on the 80mm core.

Followed wololooo over 7 years ago

Commented on Ultimaker 2 Knob over 7 years ago

I added a few "wrinkles" to the knob so that it does not slip when grabbing. Thank you for uploading the SLDPRT for easy modification. Not sure how to upload a remix of it yet. Further I wanted to note, that you do not need to glue something on the knob to get it out. Just take the hex key and push it out from the back (there is a little hole).

Published Architectrural Study over 7 years ago