Span2 tinkergnome2

TinkerGnome

  • Joined on Dec 21, 2014
  • Unknown
  • 174 times favorited
  • 13,525 times downloaded
  • Ultimaker 2
    Utm2 small

    Ultimaker 2

    Printer

Activity

Followed kmanstudios about 3 years ago
Followed Daniel Norée over 3 years ago
Favored UM3 buildplate distance tool almost 4 years ago
Published Spool Organizer almost 4 years ago
Published Screw Cap & Nozzle for EU3 Cartridges almost 4 years ago
Commented on Ultimaker2 Spoolholder small about 4 years ago
Probably not... I'm not sure which picture you are referring to... I printed it flat on the build plate with supports for the small fins.
Followed gudo over 4 years ago
Followed JustKrys over 4 years ago
Followed SyntaxTerror over 4 years ago
Favored UltiSandervG over 4 years ago
Favored Hardcore Nozzle Changer over 4 years ago
Followed Didier Klein over 4 years ago
Commented on Ultimaker2 Spool Rack Version 2 over 4 years ago
Cura defines a build area of 223x223mm. It works, if you reduce the skirt distance until it fits (e.g. to 0.6mm for a 0.4mm nozzle) - or set "Build Plate adhesion type" to "None".
Followed Adrien_12 over 4 years ago
Favored Ultimaker 3 Spool holder over 4 years ago