×Read this message from Erik, founder of YouMagine
9f21abc617b0647ae1eb63acd6c414a0?default=blank&size=170

vel0c1ty

  • Joined on Mar 31, 2020
  • Unknown
  • 31 times favorited
  • 4,306 times downloaded

Activity

Updated 3DVerkstan Face Shield - Modified over 2 years ago
Updated 3DVerkstan Face Shield - Modified over 2 years ago
Updated 3DVerkstan Face Shield - Modified over 2 years ago
Updated 3DVerkstan Face Shield - Modified over 2 years ago
Updated 3DVerkstan Face Shield - Modified over 2 years ago
Updated 3DVerkstan Face Shield - Modified over 2 years ago
Commented on 3DVerkstan Face Shield - Modified over 2 years ago
Use a hammer on the knife. It will split that with little issue. The only problem in general I am having is the rough texture on the bottom of the higher masks. I'm using an iron to smooth those out currently and then a soldering iron to fill any holes.
Updated 3DVerkstan Face Shield - Modified over 2 years ago
Updated 3DVerkstan Face Shield - Modified over 2 years ago
Updated 3DVerkstan Face Shield - Modified over 2 years ago
Updated 3DVerkstan Face Shield - Modified over 2 years ago
Commented on 3DVerkstan Face Shield - Modified over 2 years ago
I break them with a sharp knife and a hammer hit. If it would be helpful I can post a video of that. Also, I guess the model I had was incorrect. I've uploaded a new version
Commented on 3DVerkstan Face Shield - Modified over 2 years ago
I added a Europe model that is a 2stack design. It's a WIP as my printer is doing a run of 15 atm. If you can test this and let me know if it prints ok I can make taller stacks
Updated 3DVerkstan Face Shield - Modified over 2 years ago