YouMagine – Contributed photo: 20210216 204355
Design
Mask fitter for surgical masks
Printed on
Creality Ender 3 Pro
Result
Came out Perfectly. Excellent Idea I Love the Simplicity of it. Instead of an Iron, I used a mini 300w heatgun to mould it to my face starting from the nose, then I did each side of the nose separately. I found the mini heatgun gives me more control and moulds to my face much better.
On my Ender 3 Pro with BTT SKR 1.4 Turbo board & TMC2209 stepper drivers. I used these settings:
0.2mm
Skirt of 2 lines (0.15mm from model).
Printed In ST-PLA (Creality & Elegoo).
I find ST-PLA is more durable-flexible and I can re-heat it, straighten it out on a steel ruler & remould again to my face (see foto).
Description
Awesome Design & Well Done :-D