3d Printed Tap GuideMaker/DIY
Creative Commons Attribution Noncommercial Share Alike
Commercial use is not allowed, you must attribute the creator, you may remix this work and the remixed work should be made available under this license.
This is a tap guide engineerd3d & ARW. This is meant to be cast in Aluminum/Iron/Brass/etc metals.
Materials and methods
Instructions 3d Print at 20% infill, 2 perimeters and .3mm layer height.
1 - Print Base
2 - Print 4x foot
3 - Print Pegs
4 - Print Column-A in normal orientation
5 - Print Column-B in mirrored mode (This forms the opposite side of the casting)
The pegs are the registers between Column-A & Column-B
Feet are for the base. This is optional as you can remove them and tape them to have a flat bottom.
Issues are used to track todos, bugs or requests. To get started, you could create an issue.