<p><b><i><u>Comprehensive Filament Holder</u></i></b></p><p>This is a filament holder that accommodates a large range of loose filament spools.</p><p>The <b>HUB</b> can take upto 12 arms, although I usually use just 3 or 4 depending on the filament. There is a choice of 2 arm lengths, a long or short ( I tend to just stick with the long arms) and when combined with the 2 spacers allows for a large range of diameters to be held.</p><p>Additional Spaces can be used to suit requirement if using my<b><i> Dovetail Mounting system</i></b> you can mount the spindle off of the top edge of the UM2.</p><p><b>The fingers swivel open</b> to allow for the filament to be easily loaded. if weak a small length of filament can be used through the finger hoop to keep it closed or the loose end of the filament can be held to keep tidy.</p><p>the fingers and spacers all locate into each other and retain. <b>Watch out for sharp edges on the Dovetails etc.</b> when cleaning up and remove sharp edges to suit, </p><p>I printed everything at 0.1mm step and used PLA and XT.</p>
Creative Commons Attribution Noncommercial Share Alike
