Thanks for downloading!
We'd love to hear from you if the print was successful.
E3D version of NeoTko's Symmetric Dual Fans for UMO
Mount plate and fan shroud for E3D V6 hot end based on NeoTko's design
3D printer parts and enhancements
Creative Commons Attribution Noncommercial Share Alike
Commercial use is not allowed, you must attribute the creator, you may remix this work and the remixed work should be made available under this license.
Attribution
Description
This is a re-mix of NeoTko's Symmetric Dual Fans (1) to fit my E3D-v6 hot end mount (2).
The plate needs to be rigid, you should cut it in fiber based material (carbon, G10, ...).
The fan shroud is the "For Amedee Mod Umofancap40x40v3" from NeoTko in (1), with the center hole adjusted for the E3D hot end.
You need to extrude 2 mm of the top part of the fan cap, or use the "For Amedee Mod Umofancap40x40v3 Scalabletops" from (1).
Materials and methods
- a piece of fiberglass (G10, FR4, ...) or carbon 2-3mm thick
- M3 screws/nuts to to hold the plate under the hot-end holder
- 40mm 24v fans
Documents
Edit in 3dslash
Issues
Issues are used to track todos, bugs or requests. To get started, you could create an issue.
Comments
Ryan Lake added this to the Ultimaker Original+ Upgrade collection ago
Reginaldo Roberto dos Santos added this to the Future maker collection ago
Amedee commented agoI just did a quick check and it is indeed around 70mm.
I just used an M3 rod which I cut at the desired length. On one side I have a NylStop nut glued with green Loctite (it is the top side you can see on the pictures).
Andrei Gavrilescu commented agoHow long are your screws and where did you find them? I looked at some hardware stores and none had m3 that long. I measured the distance and looks like 70mm.
dashhunter added this to the My collection collection ago
scorspion added this to the imprimante 3D collection ago
Alberto Martinez added this to the ultimaker collection ago
Tommaso Nuti added this to the Ultimaker collection agoAmedee published this design ago