We are preparing your download, please wait.
Fixed filament guide for Ultimaker 3
A replacement for the annoying clip on filament guide that screws to the printer instead.
3D printer parts and enhancements
Creative Commons Attribution Share Alike
Commercial use is allowed, you must attribute the creator, you may remix this work and the remixed work should be made available under this license.
Description
This filament guide screws to your printer as a replacement for the cable cover, and you will never loose or forget it again!
It will ONLY fit the regular Ultimaker 3, not the extended version, because of the different placements of the holes for the cable cover. I might make one for the extended if it is requested.
Print it like in the image above from Cura, and you will not need any supports at all.
Materials and methods
Print the 2 parts, remove the guide bushing from the original UM3 filament guide and push it into your printed part.
To screw it to the printer, you'll need two M3x20 screws, two M3 nuts and two M3 washers.
Documents
Edit in 3dslash
Issues
Issues are used to track todos, bugs or requests. To get started, you could create an issue.
Comments
Mats printed this ago
- Printed on:
- ultimaker 3
- Result:
- Great.
- Feedback:
- Works as expected, good job!
rcozta added this to the 3d+building+pieces collection ago
Erik Cederberg published this design ago