Thanks for downloading!
We'd love to hear from you if the print was successful. If you like the design, please consider donating to the designer.
Donate to Erik CederbergFlash stand
A printable flash stand with hot shoe mount, also incorporates a hole to accomodate the locking pin on Nikon and Canon flash units.
Gadget
Creative Commons Attribution Share Alike
Commercial use is allowed, you must attribute the creator, you may remix this work and the remixed work should be made available under this license.
Description
A friend of mine asked if i had a flash stand he could borrow, so i designed and printed him one :-)
Prints without support if your printer bridges reasonably well, print with top-side down to get the hot-shoe mount as clean as possible.
Three versions included:
- Plain (just a plain stand)
- Printed thread (added a printed 1/4-20" tripod thread, works great!)
- Hexnut (added a recess for inserting a 1/4-20" hex nut)
I have not printed the hexnut version since the printed thread worked out so well for me and i did not have any nuts in the right size at home, please tell me if there is any problems with that version.
I printed this with 1.2mm perimeter, top and bottom, and 30% infill.
I used a 2,5mm drill to clean up the locking hole.
Source files:
Plain version: http://a360.co/1mGLoVT
With printed tripod thread: http://a360.co/1OsIe4q
Henut version: http://a360.co/1OsIfoV
Photo by Björn Larsson, www.bjornlarsson.se
Materials and methods
- A 1/4-20" hex nut for the hexnut version.
- A Flash with hot shoe mount ;)
Documents
Edit in 3dslash
Issues
Issues are used to track todos, bugs or requests. To get started, you could create an issue.
Comments
ralphkaeppeli printed this ago
- Printed on:
- Creality Ender-3
- Result:
- Simple and fast print, worked perfectly.
- Feedback:
- Thank you very much for this great design Erik!
vektor0815 added this to the Büro collection ago
Erik Cederberg published this design ago