Thanks for downloading!
We'd love to hear from you if the print was successful.
A small device that will allow you to fine-adjust the micrometer positioning of a typical, cheap laser diode.Maker/DIY
Creative Commons Attribution Share Alike
Commercial use is allowed, you must attribute the creator, you may remix this work and the remixed work should be made available under this license.
Insert the 6mm laser diode in the center hole, lock it with a 3mm screw. Screw the flexture in place at the desired position, fine-tune the positioning using 3mm screws from each side.
Print in a flexible plastic like PETG for the most flexible part.
Materials and methods
- 6mm laser diode
Issues are used to track todos, bugs or requests. To get started, you could create an issue.