Thanks for downloading!
We'd love to hear from you if the print was successful.
A roadside fence scaled for use with 1:32 slot carsMiniatures
Creative Commons Attribution
You can adapt, share or use this work commercially as long as you attribute the creator.
A small section of picket fence intended for use with a slot car track. The larger posts push snugly in to 6mm drilled holes to hold it up.
Materials and methods
- I used Faberdashery Architects Stone PLA filament
- Printer: Ulitmaker 2
- Software: Cura 15.4
Rotate so the fence is laying on its back.
- Fill density: 100% (solid)
- Print Speed: 30mm/s
- Adhesion: Brim
The brim is a bit fiddly to trim off round all the small posts but I found it necessary.
Issues are used to track todos, bugs or requests. To get started, you could create an issue.