Thanks for downloading!
We'd love to hear from you if the print was successful. If you like the design, please consider donating to the designer.
Donate to Ta'a PylandPipe Stem Experiments for TFV-4
Some pipe-stems I was goofing around with.
Other
Creative Commons Attribution Share Alike
Commercial use is allowed, you must attribute the creator, you may remix this work and the remixed work should be made available under this license.
Description
I was just goofing around with the idea for a pipe-stem-like drip-tip for my vape.
Wife says it looks like a whale dick.
UPDATED
Added in a couple photos to show them installed on my tank.
Materials and methods
Print them out, put em together. Might need a little tape for a good seal.
Documents
Edit in 3dslash
Issues
Issues are used to track todos, bugs or requests. To get started, you could create an issue.
Comments
Ta'a Pyland commented agoAdded some photos of it installed, found them in a box of my old prints. They still work quite well, though they get a little "drippy" after a couple rips from all the vapor.
Ta'a Pyland commented agoI designed it to fit in my Smok TFV4 Tank, and it worked well enough. Since it's so heavy on the vapor, this one tended to get really drippy really fast, but the airflow was fine (if not too breathy). I'll add in a photo of it attached on my mod for future reference.
Kristoffer Jay Martin printed this ago
- Printed on:
- M3D Micro
- Result:
- The pipe stem isn't smokable. There isn't enough air flow. The adapter is also way too short to work for a normal pipe head and for an e-cig.
- Feedback:
- increase the width of the flue and elongate the adapter.
wowowaa added this to the Vape Stuff collection agoTa'a Pyland published this design ago