Thanks for downloading!
We'd love to hear from you if the print was successful.
Printrbot Plus 1404
DXF for the Printrbot Plus - model 1404
3D printer parts and enhancements
Creative Commons Attribution Share Alike
Commercial use is allowed, you must attribute the creator, you may remix this work and the remixed work should be made available under this license.
Description
This is the file needed to laser cut the Printrbot Plus 1404 in plywood. We use Russian Birch Plywood, 6mm thick.
For all non wood components, visit http://printrbot.com/store/.
The Bill of Materials is current as of this posting. It is subject to change. Visit http://printrbot.com/support/ for most up to date documention.
Materials and methods
Hardware
1 - 1 1/2" 6-32 Screw
5 - #6 Washer
4 - M2 10mm Screw
4 - M3 6mm Screw
6 - M3 8mm Screw
46 - M3 10mm Screw
35 - M3 16mm Screw
12 - M3 20mm Screw
2 - M3 22mm Screw
43 - M3 Hex Nut
50 - M4 10mm Screw
6 - M4 22mm Screw
1 - Hex Nut Locking - M4
1 - M5 16mm Screw
8 - M6 Set Screw
1 - 3/4” Spring
4 - Washer - 3/4"
1 - Extruder Gear w/Set Screw
2 - 8mm Nylon Spacer
Rods
4 - 15" Smooth Rod
2 - 13" (330mm) Smooth Rod
2 - 12.5” Acme Rod - 3/8"
Belts, Pulleys Bag
1 - 20" GT2 Belt
1 - 38" GT2 Belt
2 - GT2 Pulley
4 - GT2 Set Screw
Motors
5 - Large motor
Board Bag
1 - Electronics Board
1 - Raspberry Pi w/ SD card
Wiring Bag
1 - Hotend Power Cable
1 - Hotend Thermistor Cable
1 - Thermistor w/ Cable
1 - Motor Extension Cable - 6"
1 - 2" Jumper Cable
1 - Z Motor Coupler
1 - Power Y Adapter w/ Regulator
1 - Ubis Hot End (1.75mm, 0.4mm tip)
2 - End Stop
1 - Fan Extension Cable
1 - 30” Wire Wrap
1 - 10” Wire Wrap
1 - Fan
1 - Fan Shroud
1 - Micro USB Cable
Bearings
1 - 625 Bearing
3 - 624 Bearing
2 - Spring Couplers - 3/8"
2 - Delrin Acme Nut - 3/8"
15 - Zip Ties
Block Bag
6 - 12mm Z Block
5 - Bearing Sleeve - 12mm
1 - Bearing Sleeve - 12mm tapped
1 - Aluminum Extruder Set
Heat Bed Bag
1 - Heat Bed (8" x 8")
1 - Aluminum Bed (10" x 11")
1 - Kapton Square (10" x 10")
ATX Power Supply
Documents
Issues
Issues are used to track todos, bugs or requests. To get started, you could create an issue.
Comments
electracks added this to the pop collection ago
Taylor Street added this to the Printrbot - Printers collection ago
Shree Harsha added this to the printer collection ago
printrbot published this design ago