Slider for a 30 x 30 Alu System Profile Type B Nut 8
a slider for a 30x30 system profile nut 8 to use it as a simpe linear guideMaker/DIY
Creative Commons Attribution Share Alike
Commercial use is allowed, you must attribute the creator, you may remix this work and the remixed work should be made available under this license.
This part slides in a nut 8 system profile (designed for a 30x30 b type) and is used as a simple linear guide on a table saw.
Materials and methods
I use tough PLA as it is more durable than regular PLA but prints just as easy. In my case the draft quality setting of 0.2mm layer height was good enough. The part should be oriented with the flat side down (actually upside down) and the walls are made so that there is no actual overhang. It can and should be printed without support as it would be tedious to remove it. The model is set for the right amount of tolerance on my Sidewinder X1 so that it moves easily but without too much of play.
Issues are used to track todos, bugs or requests. To get started, you could create an issue.