Thanks for downloading!
We'd love to hear from you if the print was successful.
Thing 1 and Thing 2
"Would you like to shake hands With Thing One and Thing Two?" -The Cat in the Hat
Miniatures
Creative Commons Attribution Noncommercial Share Alike
Commercial use is not allowed, you must attribute the creator, you may remix this work and the remixed work should be made available under this license.
Description
My filament colors are a bit off. The colors should be red, white, and cyan/light blue.
A fine tip permanent marker seems to work for the labeling and, if you want, drawing in the face.
I've included built-in supports for the few parts that needed them.
In order to align the parts, I've left a slot that accepts 1.75mm filament. The slot is 2mm, but you may need to open it up using heat or a file. It can close up due to first layer flattening.
"And then he was gone
With a tip of his hat."
Documents
Issues
Issues are used to track todos, bugs or requests. To get started, you could create an issue.