Thanks for downloading!
We'd love to hear from you if the print was successful.
UM2 Dual Nozzle Fan Shroud
Labern's Dual Fan Shroud For Original and Olsson Heaters Block Setups
3D printer parts and enhancements
Creative Commons Attribution Share Alike
Commercial use is allowed, you must attribute the creator, you may remix this work and the remixed work should be made available under this license.
Description
Single Nozzle Version found here: https://www.youmagine.com/designs/um2-dual-fan-shroud
Disscussion about the fan shroud is found here:http://umforum.ultimaker.com/index.php?/topic/10554-um2-fan-shroud-replacement/?p=102188
Please place comments in the discussion
Will require good insulation from the heater block and not recommended for high temp prints as it could deform. Working on a metal design.
Spacers are required to stop the hot end securing screws from hitting the shroud.
Make sure your temps arnt to high so overhangs are clean and the fit is correct. Can be printed with no infill.
Documents
Issues
Issues are used to track todos, bugs or requests. To get started, you could create an issue.