Thanks for downloading!
We'd love to hear from you if the print was successful. If you like the design, please consider donating to the designer.Donate to Erik Cederberg
UM2 Extrusion Upgrade Kit Mount for UMO+
A feeder mount to mount the new feeder from the UM2+ to the UMO+3D printer parts and enhancements
Creative Commons Attribution Share Alike
Commercial use is allowed, you must attribute the creator, you may remix this work and the remixed work should be made available under this license.
This is the latest revision of my mount to be able to upgrade a UMO+ with the UM2 Drivetrain Extrusion upgrade kit to be able to get the same feeder and printhead as the latest and greatest UM2+
Prints without support on the top edge, or lying down with support.
The long slot is for cable management, you put the whole bundle in there and fasten it with three zipties
It should even be possible to use this to upgrade a non-plus UMO if you also get a PT100 amplifier board.
Materials and methods
- Ultimaker Original Plus (not original since the UM2+ head uses a PT100 sensor)
- Ultimaker UM2 Extrusion Drivetrain Upgrade Kit
- 3 Zipties
Issues are used to track todos, bugs or requests. To get started, you could create an issue.
You saved my ASS!!!! Thank you so much
How many e-steps I have to set?
Nice one... Buy Generic Viagra Online http://www.menstwilight.com/generic-viagra.html
@Jack: Swap a pair of the motor cables, then it will run the right way.
Hello, my feeder is running backwards. any advice?
Thanks a lot for the designs!
For everyone else who are going to use the design(s), please se Neotko's extensive installation guide: