×Read this message from Erik, founder of YouMagine

Bag Clip hinge Tütenclip Scharnier

for closing with hinge

Commercial use is allowed, you must attribute the creator, you may remix this work and the remixed work should be made available under this license.

It will be printed in one piece. PLA 0,15 Layer

with support Only board.

good is also 100% infill

1. not too hot print, always retraction, Lift 0,08

2. when the hinge glued, then minus extrusion multiplier!

I wish you success

update 1: not so tight

1 Teil

Issues are used to track todos, bugs or requests. To get started, you could create an issue.

EduardoTS added this to the IMPRIMIR collection over 1 year ago

JPMMS added this to the Cozinha collection almost 2 years ago

JPMMS added this to the Utilidades collection almost 2 years ago

tripptrapp added this to the toMake collection over 2 years ago

goose969 added this to the Things_to_print collection almost 3 years ago

joma added this to the tools collection over 3 years ago

charlyTN added this to the useful collection about 4 years ago

asdfwooprint added this to the organizational ideas collection over 4 years ago

suederi added this to the Tools collection over 5 years ago

Paulo Rodrigues added this to the Usefull Stuff collection over 6 years ago

Paulo Rodrigues added this to the Home Gadgets collection over 6 years ago

MavericksDesign added this to the Things to Make collection over 6 years ago

Lacro59 added this to the other collection over 6 years ago

Paul C added this to the Bag Clips collection over 6 years ago

Zs0lt added this to the Things to print collection almost 7 years ago

Norbert published this design about 7 years ago