Thanks for downloading!
We'd love to hear from you if the print was successful.
Bar End Plug with open source hardware logo
Plug is designed to fit even quite damaged handlebar ends
Maker/DIY
Creative Commons Attribution Share Alike
Commercial use is allowed, you must attribute the creator, you may remix this work and the remixed work should be made available under this license.
Attribution
In case of cut-out it is obvious, end plug design is mine.
Description
Ends of my handlebars are so damaged that plugs attached to foam grips, were impossible to pressfit, so I designed ones which should be easy to fit and will quite well lock in place. They were designed for bars with 20mm inside diameter.
Materials and methods
I printed them using Fiberlogy Fiberflex 40D, with 2 shells, 25% triangular infill and no supports.
I think that any flexible material should be a good choice, I wouldn't create it from something brittle like pla.
Edit in 3dslashIssues
Issues are used to track todos, bugs or requests. To get started, you could create an issue.
Comments
Gibrealista published this design ago