Thanks for downloading!
We'd love to hear from you if the print was successful.
Dust Filter
A dust filter that can be put onto the filament after you've loaded it into the machine.
3D printer parts and enhancements
Creative Commons Attribution Noncommercial Share Alike
Commercial use is not allowed, you must attribute the creator, you may remix this work and the remixed work should be made available under this license.
Description
Other filters I've seen assumes you aren't absent minded and remember to put the filter on before loading the filament. Well, I'm not always that kind of person so I designed this one that can be clipped on whenever you feel like it.
Documents
Issues
Issues are used to track todos, bugs or requests. To get started, you could create an issue.
Comments
The information is good, i need more, i'm still learning about it.
run 3

- Printed on:
- Tronxy X5S
- Result:
- Overall a nice small accessory for the system. Not sure if my printer needs further configuration or better setup, but it seems there are too many residual filaments on the final product, demands a substantial deburring to get a clean outcome.
- Feedback:
- I wish the closingflap could be 1mm tighter, as the unit tends to open when filament exerts some side pressure on the piece.
Great thing!
Is it possible to get the CAD File?
Thanks a lot
It's a good idea, but the hinge when printing welded to each other and come into motion.
Hi, I`ve been using these since my start in 3D printing and I love them, they are easy to print very usefull can be moved back and forth and i guess they work for both 3 and 1,75 because the opening is wide enough.
Assuming this is designed for 1.75 filament?
I am using it and it is great, sometimes when I print a new one it does not "break" lose at the hinge but I guess it was printed with some different setting.
I love the possibility of putting it after...
Thanks