×Read this message from Erik, founder of YouMagine

Eel - Maker Faire Gumball Challenge 2016

This was created for the Ultimaker Gumball Challenge to be featured at the Bay Area Maker Faire 2016.


Creative Commons Attribution Share Alike

Commercial use is allowed, you must attribute the creator, you may remix this work and the remixed work should be made available under this license.

Learn more or download attribution tags


Materials and methods

For the competition, we printed the files using PLA and the Ultimaker 2. We used Cura and the following settings:
- Layer Height : 0.15
- Bottom/Top thickness (mm): 0.8
-Bottom layer speed (mm/s): 10
We printed over 100 of these in several days and we learned that the bottom layer speed is crucial for success in bed adhesion. Depending on the quality of the PLA we were using, we also needed to use glue or blue painters tape to keep the model from printing.



Issues are used to track todos, bugs or requests. To get started, you could create an issue.


3d8d5b2c84c0889af31398216a4c8ca3?default=blank&size=40kmassic published this design ago