Thanks for downloading!
We'd love to hear from you if the print was successful.
Embryo Washer
Embryo washer basket
Other
Creative Commons Attribution Noncommercial Share Alike
Commercial use is not allowed, you must attribute the creator, you may remix this work and the remixed work should be made available under this license.
Description
We use this in the lab to wash embryos through various solutions without loosing them.
Materials and methods
I print these for our lab in CPE+ so we can dishwash them at 85 degrees C
It also works fine in PLA.
This design is a bit tricky to print because of the thin mesh. It is important to make the layer height exactly 2mm (Including 1st layer!) so the X and Y directions of the mesh print on their own layers, otherwise the slicer will try to make tiny squares which will fail, instead of long criss-cross.
Documents
Edit in 3dslashIssues
Issues are used to track todos, bugs or requests. To get started, you could create an issue.
Comments
zebrafish published this design ago