Thanks for downloading!
We'd love to hear from you if the print was successful.
Face Shield - Adjusted for Smaller Bed (Replicator 2)
Adjusted to fit Replicator 2 bed
COVID19
Creative Commons Attribution Share Alike
Commercial use is allowed, you must attribute the creator, you may remix this work and the remixed work should be made available under this license.
Attribution
Description
This model has 5% narrower to fit my print bed. Adjustments were not globally scaled but adjusted points to ensure model integrity remains.
Additionally the tabs on the holes were enlarged to compensate for the change in dimensions. I may adjust this and repost after more testing.
Materials and methods
0% Infil
3 Shells
Documents
Edit in 3dslash
Comments
Josh Ingleby created issue Stacked Print Issues agoJosh Ingleby commented agoThe additional versions allow you to print multiples in one go and snap them apart afterwards. This may not work as a shareable file as it is worth watching a youtube video (below) on stacking prints and then printing a simpler model and tweaking the spacing.
I found .04mm air gap to be most suitable for myself, though the video suggests slicing would round this number relative to the layer width.
Josh Ingleby published this design ago