Thanks for downloading!
We'd love to hear from you if the print was successful.
FPV Range Video Ground Station Antenna Tracker
An antenna tracker for the Range Video Antenna TrackerGadget
Creative Commons Attribution Noncommercial Share Alike
Commercial use is not allowed, you must attribute the creator, you may remix this work and the remixed work should be made available under this license.
An antenna tracker for the RVGS.
Also needs two of these:
Fits a standard DVR and a 3600mAh battery. All .scad files are included so you can adjust the distances as needed.
Slic3r complains about the main model but it prints. Ignore the thin lines where the servos go. They won't print or if they do they can be cut away.
Print at .2mm, no supports, in ABS. You may need a brim to keep things from curling.
Materials and methods
Three Hyperion Standard size servos (Atlas DS 20).
Lots of 6-32 bolts, washers and nuts. Some are pan, some are flat.
1 637112 ServoBlocks with Hub Shaft Standard Futaba
2 525123 Hub Servo Shaft Combo Futaba
1 535049 .500 inch ID x 1.125 inch ODFlanged Ball Bearing
2 585436 45 Degree Single Angle Channel Bracket
2 585422 Flat Dual Channel Bracket
1 545468 1/4-20 Round Screw Plate
1 585424 90 Degree Single Angle Channel Bracket
Issues are used to track todos, bugs or requests. To get started, you could create an issue.