Leg replacement and extension for Cherry KC 1000 Keyboard
Legs for replacement or to increase inclination of a keyboard.Other
Creative Commons Attribution Share Alike
Commercial use is allowed, you must attribute the creator, you may remix this work and the remixed work should be made available under this license.
The design is based on the original keyboard legs.
Here are two keyboard leg designs.
One is the same length as the original of the keyboard.
The other one is extended by 2cm, to increase inclination of a keyboard.
They clip into place like the original.
Extended version is only so long, that the keyboard still remains supported by its front rubber pads, so it doesn't slide.
If it saved your keyboard you can tip me here here: https://paypal.me/ZigaM3
I also design on redbubble: https://www.redbubble.com/people/reintegration/shop
And I promote my RB designs on Pinterest: https://www.pinterest.com/reIntegration42
Materials and methods
Layer height: 0.3mm or 0.2mm (nozzle 0.4mm)
No print supports needed.
Issues are used to track todos, bugs or requests. To get started, you could create an issue.