Pulley attachment for GoPro

Print at 0.2 mm layer height, with 10% infill. This uses 26 g of filament and takes 137 minutes.

Commercial use is allowed, you must attribute the creator, you may remix this work and the remixed work should be made available under this license.

This model was made for a competition, please download this model by following this link:

This model allow you to set your camera on a rope. If it's tilted you will have a nice rolling down, making a great travelling!

Two holes on the sides makes speed control possible by setting a string for better regulation.

Issues are used to track todos, bugs or requests. To get started, you could create an issue.

Rebecca Simmons added this to the GoPro collection over 6 years ago

isabel lorite added this to the camara collection over 7 years ago

Julienverhulst published this design about 8 years ago