Spool holder for UP Plus / UP Plus 2 with bearings

Creative Commons Attribution Share Alike

Commercial use is allowed, you must attribute the creator, you may remix this work and the remixed work should be made available under this license.

Replacement filament spool holder for the UP Plus / UP Plus 2

Clips on instead of original one, filament spool rolls on skate bearings (608).

Print holder (on the side) (100% infill, 5 perimeters)
Print clip (holes up)
Clean support
slide 5-7 608 bearings on the middle rod (pay attention rod is fragile you can break it off if you are not careful)
clip on the "clip" at the end of the holder
clip the holder in place of original one

it holds easily 1.5kg spool of filament and spool rolls smoothly and quietly

source available on onshape

ABS
80-100% fill
4-5 perimeters
support
0.3mm layer

Issues are used to track todos, bugs or requests. To get started, you could create an issue.

arhi published this design about 6 years ago