Thanks for downloading!
We'd love to hear from you if the print was successful.
Teensy 2.0 Snap-Fit Mount
A simple mount for your Teensy 2.0 development board.
Maker/DIY
Creative Commons Attribution Noncommercial Share Alike
Commercial use is not allowed, you must attribute the creator, you may remix this work and the remixed work should be made available under this license.
Description
Glue directly to your project case. Holds the Teensy 2.0 securely, but allows easy removal if needed.
Clearance below the solder pads allows for the height of the joint.
Teensy 2.0 slides into mount from front, or snaps in from top.
An alternate version where the front of the PCB is captured can be used for installations where the mount is not flush to the case side.
Fits both genuine and knock-off PCBs.
Materials and methods
Printed in Hatchbox PLA @ 0.1mm using 0.2mm nozzle.
Documents
Issues
Issues are used to track todos, bugs or requests. To get started, you could create an issue.