Thanks for downloading!
We'd love to hear from you if the print was successful.
UM2 Heatsink Fan Duct Modified
Minor modification from the original by Jamezracer. https://www.youmagine.com/designs/ultimaker-2-heatsink-fan-duct3D printer parts and enhancements
Creative Commons Attribution Share Alike
Commercial use is allowed, you must attribute the creator, you may remix this work and the remixed work should be made available under this license.
Minor modification from the original by Jamezracer.
I rounder the outside corners to help it from curling up at the corners (through on a part this small it probably wasn't needed). Everything looks bigger on the computer screen.
I also modified the air flow path to be "organic" and I removed the over hang so that this can be printed with no supports. Again, with a part this small, I don't know if it matters.
I need to order longer 2.5mm screws to install this. 16mm long screws should work.
Anyway, thanks to Jamezracer for this idea and posting it.
Materials and methods
You will need some longer 2.5mm screws.
Issues are used to track todos, bugs or requests. To get started, you could create an issue.
Reibuehl, there is a lot of discussion about this here:
But the short answer is here:
Today I tried to mount this fan duct on my UM2 but once it is installed, there is no room anymore to get the heater and temp sensor cables into the lower plastic part of the head. Is there another way to do this?
- Printed on:
- Ultimaker 2+