(WORK IN PROGRESS) Single part seal mold for "Reusable Mask PPE Alternative (MalaMask)"
single part insteasd of 2 part mold for the sealCOVID19
Creative Commons Attribution Noncommercial Share Alike
Commercial use is not allowed, you must attribute the creator, you may remix this work and the remixed work should be made available under this license.
"Reusable Mask PPE Alternative (MalaMask)"
uses a 2 part mold for casting the seal from siicone.
This is a EXPERIMENTAL mold that is much simpler to use
The original design (.AD_PRT) file is from Alibre Design.
V1 was 2.5cm too short.
V2 uses the ledge on the mask to better grip it and reaches further around the mask
Materials and methods
2 part RTV2 silicone